DMA Request Signal:
HOLD and HLDA:-HOLD is an active high input signal used by the other controller to request microprocessor about use of address, data and control signal. The HOLD and HLDA signal are used for direct memory access(DMA). DMA controller receives a requests from a device and in turn issues the HOLD signal to the microprocessor.
The processor releases the system bus and then acknowledges the HOLD signal with HLDA signal. The DMA transfer thus begins.
HOLD and HLDA:-HOLD is an active high input signal used by the other controller to request microprocessor about use of address, data and control signal. The HOLD and HLDA signal are used for direct memory access(DMA). DMA controller receives a requests from a device and in turn issues the HOLD signal to the microprocessor.
The processor releases the system bus and then acknowledges the HOLD signal with HLDA signal. The DMA transfer thus begins.
logic schematic diagram of 8085
Serial Input Output port:-
SID and SOD:-These pins are used for serial data communication.
Introduction to microprocessor 8085 and pin diagram part2